Our Community is 940,000 Strong. Join Us.


2002 Suburban Keyless Remote


911h20
12-27-2004, 01:55 PM
Does someone have the instructions to program the remote(s) for a 2002 Suburban 1/2 ton. Thanks!

Logixman
01-07-2005, 06:45 PM
Hi,
Here is a program I found that works on my 2000 suburban.
1. Get in you car (have all the remotes that you want programmed with you at this time, even if you have one that works already because this procedure will reset that one as well). close the door
2 While holding down the unlock button on the driver side door:
A. put the key in the ignition and turn to the on position then to the off position then again to the on postion then to the off position (don't be too slow when you do this, probably all four motions within 5 seconds). do not remove key from ignition yet.
B. Immediatley release the unlock button. You should hear the lock system cycle within a few seconds. This indicates that you are in program mode. If you don't hear the locks cycle go back to step 2
C.Take your first remote and hold the lock and unlock buttons at the same time for about 15-20 seconds (most instructions say seven seconds) until you hear the locks cycle. Your first remote is now programmed.
D. Repeat step C for all other remotes at this time
3. Once you have programmed all your remotes turn the ignition key to the on position, this exits programming mode.

Add your comment to this topic!