Drive axle? Need help please!

I'm havin problems gettin the drive axle in the trany. Its in but it stops about an 1/2 inch shy. I tryed using a broomstick end to hammer on the boot but the boot cracked. Can someone give me some advice to how to get it in.

Same thing just went out on me. Getting ready to start removing the part today. How long did it take to get out and back in. Any advice in advance

It comes out esay if u use a pry-bar/screw driver. A little difficult puttin it in, It should slide in if lined up with the threads(may have to use a block of wood and a hammer; hammer the end of the axle(wood against it). It stops about half an in. short of being in so I used a broom stick handle to hit it the rest of the way in>(make sure u have the axle hangin down so u can get the stick up on the top of the boot so it doesn't rip)

What size is the socket for taking off the spindal

What size is the socket for taking off the spindal

36mm

hey i just want to know WOULD IT BE POSSIBLE TO PUT A H23 IN A NON TURBO ECLIPSE???i have the whole set up, i just want somethign a lil faster. i have axles, ecu

hey i just want to know WOULD IT BE POSSIBLE TO PUT A H23 IN A NON TURBO ECLIPSE???i have the whole set up, i just want somethign a lil faster. i have axles, ecu

start a new thread. this has nothing to do with drive axles