Air intake Manifold help

ok im going to be getting a new bottom and top air intake manifold.
is this one any good. http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=36474&item=7941917496&rd=1
it comes with the top and bottom.. also how hard is it to put one in and take the old one out. and i have a stock hood i wont have to get a new hood will i. some one help me thanks alot.

Hey that place is only 60 miles from me!

If you have a foxbody 'stang it's a bolt-on. Just don't overtorque the bolts and you'll be fine.

If you have a '94-95 GT you'll need an elbow from Edelbrock, TFS, or FRPP and you may have to cut or remove the hood liner to prevent rubbing, otherwise it's a bolt-on.

ok im going to be getting a new bottom and top air intake manifold.
is this one any good. http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=36474&item=7941917496&rd=1
it comes with the top and bottom.. also how hard is it to put one in and take the old one out. and i have a stock hood i wont have to get a new hood will i. some one help me thanks alot.
It's not that bad just need to take the throttle body and air intake off. Then remove the manifold (simple it's 6 bolts). The bottom is a little bit more, disassemble the fuel rail and lines, remove injectors, and disconnect all hoses then remove (8 bolts). Make sure to get a new grommet-pcv filter, and gaskets. Put some penetrating oil on all the bolts to loosen them up. When I installed my intake manifold 2 bolts in the lower manifold were seized into the heads so I had to have them machined out.

is it a good one. and what is a foxbody mine is a 1990 GT. i think i know what your talking about.

ok i got the top part off, ive herd that you need a tool to get the injectors out, what is it called?
Also off the subject, can i get a pully that goes on my alt. that makes it spin faster, so it puts out more power. Thanks

Nope, your alt. puts out max amps between 2500-3000 RPM anyway. Most guys run underdrive pulleys to decrease drag on the motor.

Tool for injectors? I use my bare hands. Just work them back and forth and pull firmly, put a little oil on the O-rings prior to re-installing. Don't even have to disconnect them from the wiring if you don't want to.

a foxbody is a mustang built on the fox chassis, being 79-93 year wise.

yeah that is what i thougth with the fox body.