Supra Suspension set-up for launching?

Are there any web sites, or aftermarket internet sites that sell, or have tech write ups about the way the supra can be set-up for the 1/4?

I will be install the engine below in a R32 GTR, that will be used for drag/street racing. I figure that since the Supra guys have basically the same rear suspension as the GTR, they would have some good info on the suspension set-up.

Tony

http://files.automotiveforums.com/gallery/watermark.php?file=/503/649000_0130.JPG

http://files.automotiveforums.com/gallery/watermark.php?file=/503/649000_0126.JPG

http://files.automotiveforums.com/gallery/watermark.php?file=/503/649gtrblue.jpg


http://files.automotiveforums.com/gallery/watermark.php?file=/503/649Fit-med.JPG

http://files.automotiveforums.com/gallery/watermark.php?file=/503/649fit2-med.JPG

Best advise is put the motor in it with your suspension you plan to run and test and tune it as long as it takes. Have two or three spotters watch your car at the line and see how it acts and go from there, but the absolute bottom line on it comes down to driver's feel for the car. Let the spotters tell you whats going on with the car but give them feedback on how it feels

Actually, I totally agree with you. I just did not know if there was some aftermarket suspension parts, that you guys installed on IRSs to help launch. So, I could look at them, and see if I could fab something up, to do the same thing.

I have not found anything out there that will really help other than what I posted earlier. I hope it good enough, sorry.

Its cool, I am researching all the IRS cars, now:)