96 avalon factory keyless remote programming
rpsly
11-30-2004, 11:42 AM
Programming for 96 Avalon remote
1. Remove key from ignition
2. Locate bulb failure warning module in truck near left trunk
hinge and disconnect electrical connector.
3. Jump pins 11 & 12 of connector with short wire or paper clip
4. Door locks will cycle
5. Press any button on remote keyless entry entry transmitter
6. Door locks will cycle
7. Repeat steps 5 & 6 for another transmitter
8. Remove jumper from connector and reconnect to module
NOTE: A max of 2 transmitters can be programmed to a car
1. Remove key from ignition
2. Locate bulb failure warning module in truck near left trunk
hinge and disconnect electrical connector.
3. Jump pins 11 & 12 of connector with short wire or paper clip
4. Door locks will cycle
5. Press any button on remote keyless entry entry transmitter
6. Door locks will cycle
7. Repeat steps 5 & 6 for another transmitter
8. Remove jumper from connector and reconnect to module
NOTE: A max of 2 transmitters can be programmed to a car
Automotive Network, Inc., Copyright ©2026
