where is the ebrake wire on 92vr4

wheres that friken ebrake wire. I cant seem to find it.

You can tighten it by taking off the center console (the big bit that flips open for storage), a total of 4 screws, I just tightned up mine yesterday. On mine there were two wires connected to a single wire out of view (all between the E brake and the now exposed airbag controller I think), there will be a nut on a thing the size of a sprk plug and you just tighten that up if thats what your doing.

im just looking for the wire so that i can put my turbo timer on it

Well the only wire I've gotten to is there.

Edit: heres a how to with pics http://www.team3s.com/~egross/3S/Mods/TT/TTimer/index.html

um, I think this is in the FAQ...if not, check www.stealth316.com, search around that site and there are detailed instructions for installing a Turbo Timer, with the wire you are looking for.

remove you ebrake boot, center cosole and side, and you should be able to find it there.

what color is it?

"To ensure that the Turbo Timer will not allow the car to operate if the emergency brake is not engaged, you'll need to splice into that wire and connect the Turbo Timer's wire to that. The OEM wire is shown here - it's near the base of the emergency brake handle assembly and is a single (yellow, green stripe) wire. Attach your T-tap to this wire wherever it's convenient. "

This was taken from the link Thourun already gave you 15 hours ago...when people give you directions to the answer you are looking for...please take the time to do some reading/searching on your own.

i read that article but when i looked for my wire i cant seem to find that color and when i did it didnt work. plus that wire i found was by the ecu. plus the article is for a 95 i have a 92 they change a lot of stuff between those years.

take the kick panel off, that piece of carpet thats next to your right leg when you are driving. Just pop the screw cover off thats about where your knee rests, unscrew it with a phillips head, then there's a pop screw down by the accelerator pedal, just reach down there and pull the kick panel loose as it will just pop out on its own. Now you have the whole few of the side of your console. Just look back by the e-brake, there should be just 1 wire, and i believe its gray, and just splice into it, tape it up, and your good to go.