b16 head on h23??

hallo,

kan i put a b16a or b16a2 head on a h23 block. If yes, is b16 head differen from h22 head?
how much hp kan i make out of h23 with vtec head?

thanks,

as far as i know you cant put a bseries head on a h series block...if you want to make your car vtec just get a h22 vtec head and put on it...you can get one for about $200 on ebay

No, you can't put a B16 head on a H23 or any H series...only a B series.

yea band h series blocks are diffrent, just look for a h22a1 head and stick it on there

What do i need to replace to make the hole thing work, like a h22 ecu or after make ecu for v-tec, h22 timing belt.

H22A1 head - wiring for vtec solenoid - P13 ECU - and lots of HIGH octane gas cause your compression ratio will be through the roof. you are better off just swappin in a complete H22 - fewer problems - safer engine - almost the same hp gain.

What do i need to replace to make the hole thing work, like a h22 ecu or after make ecu for v-tec, h22 timing belt.

i got a question.......can not using high octane fuel in my 94 prelude (h22) cause me to spin a bearing in the block.....if not what do you think could have?

i got a question.......can not using high octane fuel in my 94 prelude (h22) cause me to spin a bearing in the block.....if not what do you think could have?
check your oil and don't go past redline

check your oil and don't go past redline

even if it is spoon chipped.....i had lots of oil but i was running this other car takin it to like 8000rpm......?

The Spoon chip allowed you to take the engine to a higher RPM. This does not neccesarily mean that it is safer to do so. The Spoon chip killed your H22A.

The Spoon chip allowed you to take the engine to a higher RPM. This does not neccesarily mean that it is safer to do so. The Spoon chip killed your H22A.

damn that sux......now i need a block....and i don't know where to get one for a good price.....