Guages and pods HELP!!!

Ok i want to intall a transmission cooler,and i want a temp guage for it. and also maybe a air/fuel guage. SO the question is how do i wire for it and install it on the side on the car!! Thanks -rip

transmission temp gauge, you'd need to get a temperature probe welded into your transmission pan or find some other place to install a probe where it makes contact with your auto tranny fluid. Then you'd run the probe's wires up into the engine bay and through the firewall where it comes out above the brake pedal inside the car. Drop the lower part of the dash and run it up to the a-pillar where you will have your a-pillar gauge pod. Same thing with the a/f gauge, you hook the power up to a power source that turns on when the car does, a ground source, and the white wire will go to your O2 sensor wire which is by your ECU. I still say its pointless to get an A/F gauge unless you have a wideband set up for your car.

http://www.stealth316.com/2-wiring-tips.htm -light wiring

http://www.stealth316.com/2-a-pillar-cover.htm -removing a pillar

http://www.stealth316.com/2-autometer3373.htm -installing gauge in a pillar

These may help a bit