window film

i have a white car and i want to get the white visor on the front and read wind shield, is that something i can do myself or what and how much would it cost either way

anyone?

i had it done. $40 each. $25 was parts and the rest was labor. stupid ass labor charges man. its definitly not that hard.

make sure you clean your windshield to your sepcs before getting it. they usually wet it down too.

heres a few pics

http://photography.plex.nu/my_car/civic_01-12-07/civic_01.JPG
http://photography.plex.nu/my_car/civic_01-12-07/civic_05.JPG

where can i buy something like that? or where can i get it done?

i had it done at a place called motorgraphic here in west haven, ct. they so all sorts of graphics for cars and they make signs for stores and shit too. they do good work. look around your area for places that do graphics.

go to autozone. for $8, they have a kit that includes 1 piece of white vinyl sunshade and a set of letters and number. just put the sunshade on and discard the numbers/letters/etc. you will have to cut it yourself however. put it on, spray it with water mist, use a credit card and push air bubbles out then cut the banner to form with your winshields contours

i personally would try and get it done by a pro if possible... i wouldnt wanna try something like that along. my friend bought a kit like that from pep boys and it looks like FUCKING SHIT!!

i did my visor myself it was not that hard and then i had a place put on text onto it. my visor was 25 dollars and the text was only 20. you can do the visor yourself it is not that hard.

heres my pic:

http://images.fotki.com/v2/free/2102/2/23733/59292/civic4-vi.jpg?1011910073

figure out how low you want it to go down the winsheild
use a tiny bit of soap with water and put that solution on the winsheild

lay it over the solution and pressdown.. and push out all bubbles..

use a razor and cut around the edges of the winsheilf to make it fit.. its better to have another person helping you.