my guage light and tail lights dont work

i blew a fuse so i went to change it so i can get my lights and shit back but i put it in turn my lights on and blows again...i tried 4 different fuses and its still blown i dont know whats wrong with it

put a higher amp in it, like if u have a 20A in there put a 30A in it and u should be fine

Check to make sure you don't have a wire in that circuit pattern (wires leading to that bulb) shorting out somewhere.

If you did an aftermarket stereo, there is a wire in there that runs through that circut. Make sure all of your wires are hooked up right, and that theres not any bare wires laying up against metal.

put a higher amp in it, like if u have a 20A in there put a 30A in it and u should be fine


Thats about the worst thing ou can do. Like everyone else said, check for a short circuit in there somewhere.

:dunno: my b

by far i almost died when i read that, never over amp a circuit. i agree highly that a wire from your deck is touching the metal frame back there, cuz when i installed my first deck i kept blowing that fuse too, until i saw the wire.

I think the only time you can get away with over-amping a fuse link is if you remove the relay part of the circuitry. I have my fan motor run straight off the ignition with no relay with a 20 amp fuse and works like a charm...

Anyway, I bet you got a bare wire touching metal somewhere.

Yeah, check your radio/cd player wires and make sure they aren't touching the metal bracket. I blew mine when I was changing bulbs in my climate controls right out from of Advance Auto Parts. Good thing I was there. :lol:

well, i have 30's i n almost everything under dash and its fine. . .

yeah its fine till your car catches on fire, and dont say it cant happen because I'v seen it happen. Theres a almost brand new eclipse spider in the junk yard that it happend to.

it almost happened to my car too, the old owner put a 50a in the radio fuse, and after my first deck install, i noticed smoke and electrical wires burning under my dash.