Putting the Lights back on the Rad Support?

I'm re-building the front end of my 91 S-10 and I'm having problems putting the light fixtures on the new Radiator Support. I have the Front Lights and their backing fixture (for the adjustement screws) and that's it.. how the hell do they hold on to the Rad Support?

There are no holes in the support and the Light Fixture doesn't fit into the Light Holes on the support. The adjustment screws can't hold the lights all by their own either. Any ideas? Am I missing a piece? I've searched through my old parts and I don't think I've missed anything.

Here's what the Support looks like:
http://www.chevyautobodypartstore.com/cgi-bin/auto-body-parts/CHS10PICKUP6954Q9193.html

Yea,you might have gotten the wrong support.There are 2 different rad supports and the difference was the light location.

Yea,you might have gotten the wrong support.There are 2 different rad supports and the difference was the light location.

No, I'm sure it's the right one. I've compared it to the old and they're exactly the same. Even on the old one, I can't figure out how to stick those lights back in.

If you think that my 85 setup might be the same e-mail me at [email protected] and I'll try sending you photo's in the next couple of days

The 2 rad supports look very close but the one has the light locations just a little bit off.You say that you just need to know how they can go on though.Well each light has a bucket that 2 adjusters go into(1 on top and 1 out to each side)and 1 spring that goes to the inside.Thats it.Hope this helps.

The 2 rad supports look very close but the one has the light locations just a little bit off.You say that you just need to know how they can go on though.Well each light has a bucket that 2 adjusters go into(1 on top and 1 out to each side)and 1 spring that goes to the inside.Thats it.Hope this helps.

Oooh, the springs! How/Where are those placed?

Look for the the metal that is stamped out so that a spring can go through it.Then it just goes onto the corner of the headlight bucket.It also has a indent so the spring will not pop out once it is in it.