HELP- sticky crap comin out of my spraycan and onto my model!!!!

Im using krylon white primer and whenever i start to spray, this yellowish-white sticky stuff comes out of my nozzle in a thin line and clogs it. I unclogged it and started spraying, but little specks of the sticky stuff fly onto my model :mad: !!! I heated up the can in hot water for ten minutes like Pman says, and i shook the can for two minutes, but it still happens!!! Any suggestions?

btw, the stuff that comes out of the nozzle is like the thickness of silly string, and it is VERY sticky

you might have an old can. If that's not the case then try to switch nozzles. I'm not sure what else it could be if you did do what you said you did.

try to put a little thiner on the nosle (let it work for couple seconds) and spray it holding it upside down (not on the model but in the air) untill you get only air out of the can. Than twist it back and try it again. If problem is not gone throw bottle and buy new one (sorry)

how old is it?

The can is only a week old, and i already tried evrything u guys said. Ive got no money and now i got to buy another can of primer, GREAT!!!!!!! :banghead:

I wouldnt go with krylon, Ive had too much problems with them.

Maybe go back to the place u got ur primer and get a refund or something?