Replacing factory stereo

I just ordered a new Kenwood stereo and I was just wondering if its hard removing the dash to install a new stereo. I saw the website at http://members.shaw.ca/johnz24/howto/2kaudio.html on how to do it but I would like some insight from people who have done it and what problems they have run into so I'll be prepared and hopefully have no problems.

I was also wondering if theres a printable version with pics of the how to remove dash link on that site.

it's not that hard to remove the dash there is about 8 screws and the top part of the dash comes out, then 3 more and the trim around the stereo comes off if u want i can email u some pic of where the screws are located.

Yea that would be appreciated if you could. [email protected] is my e-mail

Well I found a nice link on how to remove the dash with some good pics at http://www.umes.mb.ca/~jy/lundis/ I really think I should be ok installing it now.

those pics r dead on that's all there is to taking it apart.