bearings

sorry to keep buggin you guys about my rear-end but im really trying to not screw stuff up. the axle bearings at the ends of the axle-tubes (farthest from the diff), how do those come out and go it. i have a slide hammer and it looks like i can just muscle them out. is this how you do it? also how do they go back in? will the bearing only go so far or do i have to measure how far its supposed to be? little help please...

dont really know bout the 4th gens. but according to my chilton's manual for 3rd gens, you have to remove the seal first then pull the bearing out with a slide hammer. then install them with a bearing "installation tool" but a hammer and a punch should get it back in there. i'm assuming there's a probly a seat that wont let ya drive it in there too far

thats what i was thinking but im trying to make sure...

i used a socket to hit mine back in

i used a socket to hit mine back in

did you use that famouse sledge of your? :lol:

i was thinking exactly that ridge

hell yea!!! i got a huge ass swing on it.. j.k... but yea i tapped it in there with my sledge

lol, i actualy figured you did. its amazing what you can do with a sledge. hey speking of witch shithead boy hasnt been around in a while. i wonder if he finaly got a life, or altleast what would be concidered a life.

lol yea.. i have a little 3 or 4lb sledge maybe.... who knows... maybe hes joined but hes finally learned how to act....or maybe he finally got laid

lol. well if someone who acts like that can get laid,(without paying for it), then there is hope for anyone and everyone.

haha yes indeed you be surprised what kinda kids got laid b4 me... LOL