hook up question

i have a head unit with only 2 pre-outs (one pair). i just got a 4 chan. amp and 2 10's... my question is the amp has 2 sets of pre-out slots and if i want to run both subs do i need to have have wires running into both sets of preouts on the amp? or is there any way i can bridge the subs using only 1 set of the preouts

you could hook up right rca to right on ch1 and left rca to left on ch2 and then hook up +spkr wire to + on ch1 and-spkr wire to - on ch2 to get most pwr. then just jump 2nd spkr off 1st spkr.you shld follow amp instructions if you have them though

you could hook up right rca to right on ch1 and left rca to left on ch2 and then hook up +spkr wire to + on ch1 and-spkr wire to - on ch2 to get most pwr. then just jump 2nd spkr off 1st spkr.you shld follow amp instructions if you have them though

I don't know what that was trying to say....


Anyway, just get 2 pairs of y-splitters. That will let you split your R rca into 3 R rcas, and your L into 3 L. Then just feed each pair into each amp

ok that is a bit easier to understand

some amps only need one input per bridged pair ... others require both. The manual should explain it

there is no manual i got it used off of a co-worker who diddnt kno much about it