302 valve adjustment

Getting ready to drop the 302 back into the 69. Had the heads reworked with hardened seats, polished and ported and new retainer studs. I'm not sure how to go about adjusting the valves from scratch. Any advise is welcomed. Thanks.

start with getting #1 top dead center.... while spinning the pushrods tightin the rocker slowy until you feel tension, then tightin 3/4 a turn.... do that with every cylinder.. make sure there all top dead center b4 you tightin them and the lifters are all the way down and even

You didnt mention if you have stud mount or pedestal rockers as the adjustment methods are different.

For stud mounts you adjust them essentially how ridge_runner said, just make sure the valve you are adjusting is on the base circle of the cam and tighten down 1/2 to 3/4 turn.

Pedestals are a little more complicated since they need shims. Crane Cams has a good adjustment how-to on their site.