Our Community is 940,000 Strong. Join Us.


Intake manifold gasket replacement question...


smaggard
06-09-2004, 07:06 PM
I had the dreaded coolant leak at the intake maifold, and now have it all apart and cleaned up.

Can anyone who's done this tell me if I put the RTV on the gaskets also or ONLY the ridges at the end of the block?

The Haynes manual says to put a bead on the block side of the gasket I think, but the picture shows paper gaskets.

The FelPro kit are the plastic and rubber type, so I'm unsure if I should put RTV on the actual gaskets???

The Fel Pro kit has no directions with it either, hence why I'm confused.

Any tips would be appreciated!

thanks

mjgjr72
06-09-2004, 07:45 PM
haynes recomends putting some on block side to hold gaskets in place.
if you got a good set with plastic base and rubber rings around openings don't worry about it just put on front and rear block make sure you get into the corners by the heads .

smaggard
06-10-2004, 07:24 AM
Thanks a lot!! Much appreciated! That was my hunch but I sure don't want to have to do this again! :)

Add your comment to this topic!