Chrysler T&C LXi 3.8 A/C and speed control problem

Hello from Finland.

I try to describe my problem with the A/C somehow:

The compressor works fine. I have just inserted freon fluids into the air conditioning system by local A/C maintenance. The problem is that the pressure sensor doesn't work.

Should both or one of the cooling fans start blow when you turn the air conditioning on? My T&C fans blow only when the engine gets warm enough.

How does this pressure sensor work? Is there any other sensors that affect on A/C system?

I have tried to clean all the fuses and relays in the fuse box.
--------------------------------

Another problem is with my speed control. It doesn't work. If anyone has good hints where to start fault detection, please tell :)

Cruise is working!

The problem was with the buttons in the steering wheel. Bad connection, needed cleaning only.

I found out that T&C LXi has two condensers. I was under the car and noticed that there's air conditioning refrigerant lines also in the rear part of the car.

I have put too little refrigerant because I didn't know about two condensers. I'll let you know if the A/C starts to work after adding refrigerant.

What did you done? I have the same problem, I tried to look for a fuse for this but no luck.
Can you describe me what have you done to solve this?