2004 chrysler sebring remote programming

Hello can someone tell me how to program the remote
thanks

Same question for a 2003 convertable. I've tried the supposedly 2002 method of pressing the lock five times but can’t get the transmitter to resyncronize.

I found the instructions via Google but they are confusing to me...

For example which steps are referring to the dealer remote and which steps are referring to the new one that you are trying to program?
Program Method A (Customer Program Method)

1. Press (LOCK) button 5 times at 2 second Intervals to resynchronize transmitter, Attempt to function transmitter, If working as designed discontinue programming.

2. Turn ignition to run position, (Allow Ignition chimes to stop).

3. Using any original (working )transmitter, press the [UNLOCK] button for 4 to 10 seconds.

4. Within the specified 4 to l0 seconds, continue pressing the [UNLOCK] button and press the [PANIC] button for 1 second and release both buttons (AN/DN release either button first). A chime will sound to indicate that the transmitter programming mode has been entered (allow 3 seconds for chime to sound).

5. Press [LOCK] and [UNLOCK] buttons simultaneously for 1 second and release (a short chime will sound for AN/DN).

6. Press and release any button an the same transmitter and a chime will sound after successfully programming the transmitter (locks will cycle for AN/DN).

NOTE.- (FOR DR ONLY) A CHIME WILL NOT SOUND ON STEP #6 FOR THE FIRST TRANSMITTER PROGRAMMED, BUT WILL SOUND UPON PROGRAMMING THE SECOND TRANSMITTER.

7. Repeat steps 5 through 6 to program additional transmitters.

8. Turn ignition to OF:F position. Transmitter programming mode will discontinue after 60 seconds (30 seconds for AN/DN and RS). (All transmitter programming must be completed within time specified).

MVT:

That procedure is for 2002. Chrysler changed it in 2003. I finally found it......of all places the owners manual. LOL