replacing radiator

i am replacing my radiator tomorrow (it finally got here) and i was wondering if there is anything i should look out for? i have a 97 av6 accord, and it looks just like a simple replacement. i just take out my old one, which looks relatively easy, and throw in the new one, anyone with experience with this? please give feedback, thanks.

You got it, remove the old & install the new.

1. Remove rad. cap / Drain rad. (may have to remove lower spash shield)
2. Disconnect electrical connection(3)
3. Remove upper rad. hose / over flow hose/tank
4. Remove support brackets
5. Lift up & remove lower hose
6. Swap fans & re-install

Now is a good time to replace hoses & clamps. After the coolant has been topped off, run car until fan comes on then crack open air bleeder near thermostat.