no spark

I just recently sent my engine out in my 92 prelude for a rebuild. i reinstalled it and hooked up all connections, but now have no spark. i doubled checked wiring connections and all were connected. I checked the ignition coil and one of the readings was off by 0.5 ohms, so i replaced the ignition coil, but still no spark, is there anything that anyone can think of that i should check, nothing was even changed on the ignition during the overhaul. Has me at the end of my rope.

check the distributor cap and make sure the "spinny thing" is in there

have good sprak plugs and wires? Is your Cam truning over to turn the rotor to make spark is the rotor hitting?

Sounds like a distributer issue... make sure you have the right distributer cap and rotor set... there are two different ones for the ludes... also cam position sensor.....

I'd say check the cheapest first like the plug wires, the distributer cap, or the not so cheap distrbuter but just start simple