Clutch Install

Ive got a 95 Integra LS with a few mods. Ive been having problems with the car not going into gear so i replaced both the master and slave clutch cylidners. that didnt work. i flushsed the whole line and everything. Now i have a new clutch ready to install..

I have a book, that shows that i can just split the tranny and install it that way, looks pretty easy to me 1,2 hour job. is that my best bet? im doing this right in my ROCK driveway so im trying to make it as easy and fast as i can.

Thankss

hopefully that new clutch came with an alignment tool? b/c mine did not and it took me 14 hours of pure cursing to get the tranny back together. i know that automotive shops rate that as a 6 hour job. and they know what they are doing. just give yourself plenty of time. and to make it easier for you, find an asphault driveway. and the book is pretty much it. follow it and you'll do fine

doeas it grind when it goes int gear, it could be your throwout bearing. It doesnt take to long to get the trans off i would say a 4hr in and out. What type of clutch did you get

its actually got 4 aligntment tools, :D yeah the book seems pretty easy to follow, ive got prerection clutch made by zoom. wouldda got an act but i didnt have the money

prefection* , no it doesnt grind when i put it in gear

i just did mine it took me about 5-6 staright working hours...it is best with a motor lift splits the time in half for the tranny mounting..just make sure u arent in a rush...good luck

i just got an act stage 4 in and am getting a new trans