Main journal clearnace

any of you other Windsor/302 guys know the reccomended clearance in the main bearings with the crank installed? i need to plastigage my crank to make sure it's ok. the crank is a forged SCAT piece. thanks for any help.

.0015 - .003

thanks for that, i went ahead and checked it anyway and it was right around .002" on each journal. endplay was .005".

now i just need to call CHP and doublecheck the torque spec on the main caps. i checked clearances using the stock spec ( approx. 105 ft. lb.) i'm using the 'street fighter' mains girdle as well, checked with it in place.

i just painted the block today, it turned out beautifully with very little overspray. i'll get some pics up here if at all possible.