Our Community is over 1 Million Strong. Join Us.

Stop Feeding Overpriced Junk to Your Dogs!

GET HEALTHY AFFORDABLE DOG FOOD
DEVELOPED BY THE AUTOMOTIVEFORUMS.COM FOUNDER & THE TOP AMERICAN BULLDOG BREEDER IN THE WORLD THROUGH DECADES OF EXPERIENCE. WE KNOW DOGS.
CONSUMED BY HUNDREDS OF GRAND FUTURE AMERICAN BULLDOGS FOR YEARS.
NOW AVAILABLE TO THE GENERAL PUBLIC FOR THE FIRST TIME
PROPER NUTRITION FOR ALL BREEDS & AGES
TRY GRAND FUTURE AIR DRIED BEEF DOG FOOD

Has anyone ever had this problem?


sipote
03-19-2004, 09:12 AM
I have a 97 chevy camaro V6 3.8 and i just bought it like 2 months ago, i replaced the power steering pump and after that the engine light came on a few days later the car just would not start, would crank but not start. the problem is that it keeps blowing up the PCM fues, any clue what could be causing my car to do this?

thank you
sipote
03-19-2004, 11:52 AM
any ideas why my fuse may be getting blown on my PCM? when car moves?

thanks
Chevyracincamaro
03-19-2004, 01:37 PM
sounds like when you replaced the pump you might have done something to the harness that caused a short somewhere, maybe you accidentally stripped a wire somewhere thats grounding to the body...
sipote
03-19-2004, 01:53 PM
maybe that is possible and we replaced the the seals on the valve covers and that took him at least a whole day to take it off and put it back the one on the passenger side where the dip stick for the transmission is..and blows when the car is moving..

thanks
4onFloor
03-19-2004, 08:33 PM
get a volt meter or ohm meter, pull the pcm fuse. i think there should be 12 volts to one side of the fuse even with the ignition off, but try it both ways. find which side is hot, then check continuity to ground on the other side, or check resistance to ground.
sipote
03-20-2004, 08:25 PM
now the car blows the fuse right away as soon as we put the fuse in the car the fuse blows it is fuse 13 initial PCM any ideas on what wires go to fuse 13?

thanks
89IROC&RS
03-20-2004, 08:49 PM
definately sounds like a short, looks like you pinched a wire somewhere, and it is grounding to the chassis, so as soon as you put the wire in, ill look into what color wires are the power feed for the PCM, i would assume it is a large guage orange wire. i would just inspect all the harnesses around the areas that work was performed, and see if you can eyeball a damaged section.
Jm93
03-21-2004, 12:05 AM
definetley sounds like a short. do like the above fellow said, and check all harnesses and whatnot around the area you worked.
4onFloor
03-21-2004, 12:58 AM
i think on a 3rd gen, the fused power to the "ecm" is a pink wire with a black stripe. but i dont know if it's the same for the 4th gen pcm.

Add your comment to this topic!