Automatic garage opener
MRT
03-17-2004, 04:50 PM
I have a 2000 Jimmy SLT, I need to program the built in garage opener
the car is equip with. I don't have a manuel, does anyone know, or have a owners manuel they can give me the instructions how to do this?
the car is equip with. I don't have a manuel, does anyone know, or have a owners manuel they can give me the instructions how to do this?
rm54
03-24-2004, 01:07 AM
This is from the owners manual from my 1999 Jimmy SLT. Have you tried E-BAY to get a owners manual for your Jimmy. They usually have some pretty good deals
The vehicle's engine should be turned off before programming the universal remote
1. Hold down the two outside buttons on the opener in the Jimmy until the indicator light begins to flash rapidly (after 20 seconds). Then release buttons. This procedure initializes the memory and erases any previous settings for all three channels. Each button can be programmed for different garage doors.
2. Decide which one of the three channels you want to program. Hold the end of the hand-held transmitter about 2 to 5 inches away from the surface of the universal transmitter in the vehicle so that you can still see the indicator light.
3. Using both hands, press the hand-held transmitter button and the desired button on the universal transmitter. Continue to press both buttons through Step 4.
4. Hold down both buttons until you see the red light on the universal transmitter flash rapidly. The rapid flashing indicates that the universal has been programmed. release both buttons once the light starts to flash rapidly
The vehicle's engine should be turned off before programming the universal remote
1. Hold down the two outside buttons on the opener in the Jimmy until the indicator light begins to flash rapidly (after 20 seconds). Then release buttons. This procedure initializes the memory and erases any previous settings for all three channels. Each button can be programmed for different garage doors.
2. Decide which one of the three channels you want to program. Hold the end of the hand-held transmitter about 2 to 5 inches away from the surface of the universal transmitter in the vehicle so that you can still see the indicator light.
3. Using both hands, press the hand-held transmitter button and the desired button on the universal transmitter. Continue to press both buttons through Step 4.
4. Hold down both buttons until you see the red light on the universal transmitter flash rapidly. The rapid flashing indicates that the universal has been programmed. release both buttons once the light starts to flash rapidly
Automotive Network, Inc., Copyright ©2026