intakes for V6

All right...you all probably already have intakes on your cars...but the only intake I can find is the Weapon R intake (not cold air or short ram), all the others are for the 4 cyl. MX3. Where'd yall get urs?

PRM makes a good one...

http://www.prmracing.com/products.html

other then that, just go to mx-3.com and check out the aftermarket section, it's got links to tons of stuff...

Is it better than the Weapon R intake? I've never heard of PRM.

weapon r is crap, prm is good, custom is better :biggrin:

go take a look at mine
http://www.cardomain.com/memberpage/211008/4

My friend offered me an acura intake, I don't know what kind, but it was cold air, so I researched whether or not it would fit, and I ran across your car domain page. I decided that I didn't want to move the resevoir. But, that might be the cheapest choice.
How much did you spend on your intake? Cause, if the $180 for the PRM is the cheapest it gets, then I'll just wait until I swap in the KLZE to get any mods.

it's probably smarter to just wait til you get your ZE...you could always go the SUPER cheap route....make it yourself out of PVC pipe....it's been done before. i dont know if there are directions on how to make it, but i've seen pvc intakes before. that one would probably run you less then 100(including the cost of a filter)

well guys...you can really go cheaper than 30$ :)