97 t&c keyless entry

I have a 97 t&c AWD that has a factory keyless entry. I have tried to install a remote car starter that has keyless entry but havent gotten that to work properly. If anyone knows how to hook this up properly or if there is some kind of kit to do this I would like the help. If you could program the remote start to work the factory keyles entry that would work also.

I have a 97 t&c AWD that has a factory keyless entry. I have tried to install a remote car starter that has keyless entry but havent gotten that to work properly. If anyone knows how to hook this up properly or if there is some kind of kit to do this I would like the help. If you could program the remote start to work the factory keyles entry that would work also.
WOW, I am impressed that you have gotten this far without messing up the BCM of the van!!! This is one of the most difficult of vehicles to do the remote start on.

Anyway, the locks is a one wire system. It should be a white/green wire. It is located in the left plug at bottom of fuse panel. Use relays and set up for negative trigger. Place a 4020 ohm resistor inline on the lock output, and a 665 ohm resistor inline on the unlock output. If you do not have a factory security system use a 1500 ohm for lock and a 250 ohm for unlock.

Does the wire have to be split in two for the lock/unlock on the aftermarket Remote Start/Keyless entry?I have a Bulldog RS114 Remote system...