1995 3/4 ton van with u-joint problem (?)
joyrider
02-13-2004, 04:11 PM
I've got a 95 van with a clunk underneath when shifting gears. I assume this is the u-joint--what's the quick 'n' easy way to check, and is there a way to replace it without tearing out the whole driveshaft???thanks!
comp
02-13-2004, 11:29 PM
it can be a trans. mount (pull down real hard on tail shaft it should flex
down, not already be on the crossmember, then see if there is just a
little side to side flex) you may have a "carrier bearing" it's a flex joint
to support a long drive shaft( move up/down/side/side) it shouldn't move
to much . u-joints are checked about the same as the carrier, apply the
pressure with a small pry bar, DO ALL THIS on flat ground with wheels
chocked so there is no load on drive-line work safe, get a shop manual
to understand this better :smokin:
down, not already be on the crossmember, then see if there is just a
little side to side flex) you may have a "carrier bearing" it's a flex joint
to support a long drive shaft( move up/down/side/side) it shouldn't move
to much . u-joints are checked about the same as the carrier, apply the
pressure with a small pry bar, DO ALL THIS on flat ground with wheels
chocked so there is no load on drive-line work safe, get a shop manual
to understand this better :smokin:
Automotive Network, Inc., Copyright ©2025