Help, Intake Gone Wrong!

I just got an intake for my 03 cavalier ecotec. I have everything in but I have one black line that is just hanging in place and I am thinking of drilling a whole in the plastic part of the intake. Should I and if so/not what should I do next. Lights in my car came on. (Theft, check gages, and a wrench w/ a repair. HELP ME I DONT HAVE ANY GUIDE TO FIX THIS!

theres a black hose or wire? did you hook any wires into your intake?

yes the mass air flow, but i also have one more that goes into the intake and i think its a fuel/air sensor of some kind... cuz my car is f**** up... can you help me?

its more like a wire

anyone! i need some help, i want to drive my car.... any help at all would be great!

i dont know much about the ecotec. but i dont think its that much differnt then the ld9 and older quads. but the quads dont have a mass airflow meter. there should be one wire that goes into the intake right around were the filter is thats the AIT (air intake temp) so your going to have to drill a hole in the intake and get a rubber gromit and put it on the hole then plug the AIT in. the best thing to do is to look at your old intake that you took out and see where all the holes are on it.

Just get a breather filter.

I Found Out What Was Wrong With The Car. My Friend Was Helping Me Take It Off (intake) And When He Did, He Put The Ground To The Battery So That I Could Not See It And Long Story Short I Did Not Put It On In. Thanks Tho Everyone