remote starter

I installed a remote starter in a 96 Dodge Caravan and everything was easy except for the power door locks. I can't find the wires to splice into. Directions say the wire color is white with dark green stripe located at the body control module. Anybody have any ideas to where to look?

The single wire you are looking for is in one of the black connectors going up into the bottom of the BCM I can't remember which one. I assume that you know about the resistor values to use on this wire? If not post again and I'll dig them up for ya! Oh ya it also makes a difference in the resistance values if you have factory anti-theft.

1996 Dodge Caravan Security Information
Constant 12V+ Red or Pink/Black Ignition Switch Harness
Starter Yellow Ignition Switch Harness
Ignition Dark Blue Ignition Switch Harness
Ignition 2 Dark Green/Red Ignition Switch Harness
Accessory Black/White Ignition Switch Harness
Tach Gray/Red Or Blue/Tan PCM Coil 2.4 Liter Engine
Neutral Safety Wire Black/White Power Control Module
Brake Switch White/Tan Brake Switch
Trunk Pin Tan/Black 40 Pin Connector at Fuse Panel
Parking Lights Light Green/White (-) Head Light Switch Harness left of Column
Head Lamp Green/Orange Light Switch
Hood Pin Brown Driver's Side under Hood
Factory Disarm White/Dark Green (665 Ohm) left Connector bottom of Fuse Panel
Door Trigger Brown/White (-) Lower right Gray Connector at Fuse Panel
Door Lock White/Dark Green (-) BCM at Fuse Panel 1500 Ohm Resistor
Door Unlock White/Dark Green (-) White Connector B58 Connector 250 Ohm Resistor
Driver's Lock Brown (+) Junction Block
Driver's Unlock Purple/Yellow (+) Junction Block
Horn Wire Black/Red Steering Column
Windows Up LF=Light Green, RF=Brown, LR=Blue, RR=Gray
Windows Down LF=White, RF=Purple, LR=Red, RR=Dark Green

I had also installed a remote car starter. Everything works fine, except for the headlight indicator wires. While I was trying to installed the headlight wire, all lights on the dash and tail light started blinking rappidly like crazy. I decided to not monkey with it and left it out. Any suggestions on what I might be doing wrong?

do you have the lay out to install a remote start on a 91 gc ??