1995 Integra dash into a 1995 Civic?

Okay I am under the understanding that to mount the dash into my civic I need the dash, heater core and the mounting brackets? and it should bolt right in?

What Do I need to do for wiring?


I was told since my car is a coupe that none of the door panels would fit? correct? So what If i used say 99-00 Si door panels seeing they are pretty similer to the integra dash and look to be the same size doors, would this work?

Kyle

Okay someone please help me out with the doors, I have the complete integra dash/heater core and eveything sitting here ready to go in but im still not sure on what to do for the doors.

Kyle

so will the dash fit in your car? or does it stick out to far and interfer with the door panels???? is the donor car a 4 door or hatch? is your car a 2 or 4 door or a hatch? a little more info may help...


gunnmen01

like i said my door is a coupe that is a 2 door, the dash is not in yet becasue i have not found door panels for it


happy new years!!!

bump, someone has to have a little info for me.

i "heard" that the integra dash is about an inch too long on both sides to fit in the civic. anyway thats what i heard. i don't know anyone that has tried it. hope this helps.


zer0 :sunglasse

well thats not what i was hoping to hear, anyone else hear of this?

it can be done just not a quick swap. little cutting here and a little cutting there.


zer0 :sunglasse

It can be done, if thats what you are asking. I have seen it done before. It's not an easy bolt in affair though.

Will the 99 civic si dash fit in the 95 civic??? you hear about that?

As I said above about the Integra dash...it can be done, though it's not a simple unbolt, line up and re-bolt affair. There's more than that involved, it's not a simple remove and install, if thats what you are asking. Anything can be made to fit, if you know what you are doing or have the right amount of money. Basically, it takes some creativity. As to the level of work to pull it off, I am not exactly sure, but I know it's not a simple bolt in like Integra seats into a 95 civic are.

So exactly what needs to be done when putting an Integra dash into a 92-95 Civic (hatch)? You said there would be cutting and a lot of work involved, but what kind of stuff specifically would you have to do? Also, what about the door panels?

Hey big guy, this post is 7 months old, make a new one asking that question, you'll get better results