does an evo with 1000+hp exist?

is there an evo that has 1000 and up horsepower??/ is taht possible?

Hey..
Not as I know.. Im working on a new engine my self at the moment, for my Evo6 TME..
It will be some between 600hp and 700hp in the engine!
But I know a company in England are working on a 800hp engine at the moment! A company I talked to in Japan has one with 750hp in the engine. and Simon Norris in England claim that he has dyno tested his EvoVII to 771hp in the engine..

So, as far as I know.... Nope.. there are no engine beyond 771hp at the moment! :smile:


MrLeone

it's kinda hard to push a 4g63 into over 600 hp range.

forget that-its hard to push any 4-cylinder to 1000 hp.

its possible to push a 4 cylinder to 1000HP...with money! hahaha...the only 700+ evo i heard of is Simon Norris's Evo. hey MrLeone, i would like to see this 600+ hp Evo of yours that you are working on...can i see!

we have an evo 3 here in NZ by the name of DOCILE, currently running over 800hp (720hp ATW), but when she had 600hp (ATW) ran a 9.5 sec 1/4! also got another evo by the name of RIPUUP with full tube chassis, aiming for over 900hp and low 8 sec 1/4s :D


docile: http://www.lowndvs.co.nz/gallery/galleries/jamboree/Show/DSCF0092.JPG
http://www.lowndvs.co.nz/gallery/galleries/jamboree/Show/DSCF0093.JPG
http://www.lowndvs.co.nz/gallery/galleries/jamboree/Show/DSCF0094.JPG

i'd love to own this evo :D still has traction problems with 4wd/slicks :eek7:

she had 600hp (ATW) ran a 9.5 sec 1/4!

How very sad that is. There is a guy in a Eclipse runing an 8.769 and he is under 600whp. Y is it a problem to get these cars in the lower numbers?

when you get up in the higher hp range, it's all about the tuning.... which many people regretablly forget to do. spend 20k on the engine, ends up going slower than b4... that must suck.

http://www.nzmmc.co.nz/nats/37.jpg


maybe because our track is SHIT, he should be well into the 8s with that amount of hp i know but our track is like 40 years old and hasnt been touched up since its build.
oh and this was with STREET tires ;)

it is POSSIBLE. after the norris car blew the piston the owner simon was considering going balls out on the engine and taking it to about 950bhp, but decided against it for reliability's sake.

this is probably sa thouch off topic but the GM ecotec engines can push 1000 HP on stock internals... just my .02

yeh but that ecotec wont make it to the end of the street without blowing something.

Also the ECOTEC has a tnedancy to spin the lobs off the cam shaft. So im assuming the engineers did not do much engineering when they built the car. Just based on that i would never own one.

even if you have to rebuild the engine after every run, 1000HP on stock internals is impressive...let me say that again, STOCK INTERNALS. that's quite the engineering accomplishment when out of the factory the engines are only putting out ~200HP

its possible to push a 4 cylinder to 1000HP...with money! hahaha...the only 700+ evo i heard of is Simon Norris's Evo. hey MrLeone, i would like to see this 600+ hp Evo of yours that you are working on...can i see!

My engine is basicly an JUN Auto 2,2L engine.

Built in Japan with Jun Auto.

There is also something going on at www.rcdevelopments.com

They claim a 800hp engine is under development!

I also found some links on TUNINGTRACKER (http://www.tuningtracker.com ), under Japan. There was an company that had one 750HP drag car!

So there are some crazy dudes around in the world.. :rofl:

//MrLeone

NorrisDesigns in England has just finished their new engine.
It blow out 805hp in the engine.. :naughty:

What will be the next step?


//MrLeone

ecotec motors lose the stock rods around 280hp.
not sure where you got the BS 1000hp claim.

i was going to mention the norris-designs cars, but you got to it already.

consider that you still don't need as much hp as a supra/skyline to get down to those times...
you can do with 500hp what a supra/skyline would need 600+ to do... ;)