Engine Specs

Hello all
im looking into replacing my old intedra ls motor with a b19c, jdm itr, or a b20 now im new to the whole engine thing so any info or specs or tips about these and any of the spoon sports engines would be greatly valued.
also if you could give me a place to fine these motors that would also be great.
thanks in advance

B19C doesn't exist - u may have mis-typed (it's B18C).

JDM ITR is a good motor.

B20 will be relatively inexpensive - and very torquey not to mention great to turbo.

The B18C1 is the 94-01 Integra GSR motor (or the JDM 94-01 Integra Si-G). 170hp (USDM) or 178hp (JDM). A very, very good motor - extremely popular and will run you around...3500 bones.

The JDM ITR motor or B18C-Spec-R (B18C5 in the US). USDM has 195hp and the JDM has 205hp. Both extremely wonderful motors, but very expensive at around 5500.

B20B/Z. Great motor. You'll have to source out a Front-wheel drive B-Series transmission (out of a Integra or Civic Si - 99-00 - or a 93-97 del Sol VTEC) and axles (again any B-Series axles will most likely fit). Not sure on the price on this one - very cheap though.

Or, you can go for the inexpensive B16A motor (same found in the 99-00 Si and the 93-97 del Sol VTEC, as well as in MANY JDM applications). Only will cost u around 2500.

www.sohfast.com is a great place to buy motors and Jerome (the owner) is cool :D

I recommend JDMclub.com for motors...they are cheap...and their prices include shipping to a port near you. so instead of $2500 plus $400 in shipping costs, you spend $2500 shipped...you have to pick it up at the port...if you don't have a truck, rent a uhaul for the day, it costs about $20....better than paying $2900...plus JDMclub.com has rather cheap prices anyways:D

Wow thanks alot thats very helpfull now im not knowldgeable at all on these topics but is the b18c a spoonsports engine?

The B18C is a Honda motor.

Spoon builds Honda B18Cs, B16s, and F20Cs.

F20C? wow how much horsepower does that have and how much does it cost?

the F20C is the Motor out of the S2000 with 260hp I think, But it wont fit in your integra cause it spins the wrong way and is RWD

Actually it has 240 hp and can be mounted in your car, but it takes a whole lot of work and is just basically a big pain in the ass.

a b20b is usdm, the b20z is jdm.

my project?

b20 turbo. the full transplant will probably run you as much as the b16's
around 2k to 3k

or

b20/vtec!!!! torque!!!!(could be t/c)
b20 block, with a slapped on b18c1 head(aka gsr) is less than what you pay for a full gsr swap.

good luck! good speed.