MPFI swap complete!
blade34609
12-25-2003, 02:50 PM
Hi,
Today I finally finished wiring the MPFI manifold and the car runs good with no check engine light or ECU codes.
The next thing I am going to do is install my SI Guage Cluster so I have a tach.
I am going to buy a Short Ram Intake off of Ebay because a pipe with a filter is fine with me. I dont wanna spend the extra $ for brand name.
After I do the Guage Cluster install and I wait for the Intake I wanna sand down the car and put primer on it.
I read where it says use 320 grit and dry sand it the use 400 grit to wet sand it. Then spray your primer. It says u also should use dish washing soap to remove any wax on the paint.
Any one got any other tips on this?
Thanks
Today I finally finished wiring the MPFI manifold and the car runs good with no check engine light or ECU codes.
The next thing I am going to do is install my SI Guage Cluster so I have a tach.
I am going to buy a Short Ram Intake off of Ebay because a pipe with a filter is fine with me. I dont wanna spend the extra $ for brand name.
After I do the Guage Cluster install and I wait for the Intake I wanna sand down the car and put primer on it.
I read where it says use 320 grit and dry sand it the use 400 grit to wet sand it. Then spray your primer. It says u also should use dish washing soap to remove any wax on the paint.
Any one got any other tips on this?
Thanks
Automotive Network, Inc., Copyright ©2026