Our Community is 940,000 Strong. Join Us.


rearview mirror compass problem


speedydog5
12-05-2003, 06:30 PM
I have a 2001 silverado z71 the rearview mirror compass calibration symbol stays on and does not shut off I did what manual says driving in circles but it still stays on and is not in calibration I tried to unplug from behind mirror to maybe reset but no luck it still stays on is ther somewhere else to check anybody know what gives? :banghead:

97BlazerLT
08-28-2005, 09:48 PM
I have a 2001 silverado z71 the rearview mirror compass calibration symbol stays on and does not shut off I did what manual says driving in circles but it still stays on and is not in calibration I tried to unplug from behind mirror to maybe reset but no luck it still stays on is ther somewhere else to check anybody know what gives? :banghead:


Just drive around normally for a little while- It will calibrate itself. I have installed 7 Mirrors for other people plus 2in my own cars.

Any other questions about these just ask!

alwaysfixinchevys
06-05-2006, 09:41 PM
I had plugged my mirror in and the direction popped up so I set it to 7(my region) and then SE popped when I was facing West. The next day I turned my truck on and every possible light was glowing looked like 100 with X's in it and the C, F letters were showing as well. Also there is a 7 point wiring harness with 3 wires in it. There is a small wiring harness that goes somewhere. I do not see a plug for it anywhere. The tint still works.

Thanks,

Brandon

97BlazerLT
06-11-2006, 05:24 PM
First of all is it wired correctly?? Second if it is Try unpluging it from the back of the mirrorand pushing it back in all the way

95ragtop
07-17-2006, 11:40 AM
The "extra" wire harness hanging out of the back of the mirror should be plugged into the compass module that is clipped on to the base of the mirror stem. This is why your display has all its segments lit. I hope you didn't purchase this mirror with the module missing. It is not available separately. All the display segments are lit when the compass module is unplugged or damaged. Hope it works out.

alwaysfixinchevys
08-14-2006, 08:30 AM
I got it to work. The smaller wiring harness goes through the back along side of the main harness and plugs into the circuit board inside.

Thanks

Add your comment to this topic!