Installing apexi n1 on 95gst

If anyone has installed apexi n1 catback on a 95gst please help. I unbolted stock exhaust ok, it was a little difficult pulling the muffler section out through the small opening of the wheel brace or whatever the name of it is. I had to hammer the bottom of the trunk in a little to allow enough clearance for the section where the three bolts go to come out. The apex pipe off of the back of the muffler will not fit back through that opening. No way. Dude said,where I bought it from, it should bolt up easily. Others said the same thing. the only way of this working would be to completely unbolt that brace and the arms of the left rear wheel, bolt the exhaust up, then bolt the brace and arms back up. Is this the only way or am i wrong? I have a 2inch drop but should that matter? The other two sections of the apex exhaust look to bolt up fine. Any help would be greatly appreciated

by taking off the wheel it makes it a lot easier unless you have a car lift!!!

its kinda late and i'm not sure if I read your post right,
but it sounds like you're trying to put it over the axle like how stock exhaust was mounted.

the N1 goes under the axle

If anyone has installed apexi n1 catback on a 95gst please help. I unbolted stock exhaust ok, it was a little difficult pulling the muffler section out through the small opening of the wheel brace or whatever the name of it is. I had to hammer the bottom of the trunk in a little to allow enough clearance for the section where the three bolts go to come out. The apex pipe off of the back of the muffler will not fit back through that opening. No way. Dude said,where I bought it from, it should bolt up easily. Others said the same thing. the only way of this working would be to completely unbolt that brace and the arms of the left rear wheel, bolt the exhaust up, then bolt the brace and arms back up. Is this the only way or am i wrong? I have a 2inch drop but should that matter? The other two sections of the apex exhaust look to bolt up fine. Any help would be greatly appreciated


wassup man? i recently installed an apexi n1 downpipe and catback system on my 95 gst.... it was pretty easy except for the end part bc i have 3" piping cat back and a 4" outlet. The part where the gas tank is in the back i could not go over the rear end and under the tank, it would not fit(a 2 and a half would prob fit barely).. I had to put it under the rear end and it sits pretty nice, doesnt bottom out or nething... if you have any questions feel free to email me @ [email protected] or go on aol instant messanger and im me @ kryptonight33... lataz