1991-94 Park Ave keyless remote programming

Hi Guys, I did a bit of searching for the procedure for my 92 Park Ave keyless programming. I see a thread on top for 91-96 but that is for 95-96 that only have the DLC connector. The 91-94 has the ALDL connector and the jumper'ing is different. Hope this hasn't been covered before....if so I appologize.

Leave key off
Jumper pin A to pin G with a fused jumper (3A)
Doors will lock and unlock
Pres the UNLOCK button on the remote
Doors should lock and unlock again
if you have more remotes press their unlock button (up to 4)
remove jumper wire
________|________
[F] [E] [D] [C] [B] [A]
[G] [H] [J] [K] [L] [M]
_________________

Thanks,

Mike

Real quick question... this may sound dumb, but I assume I'm jumping the "data link connector?" I looked through my Haynes manual, and could not find where this is located... also looked underneath the dash on the driver's side. If someone could tell me where this is on my '92 Park Ave, it'd be great. Thanks in advance.

Real quick question... this may sound dumb, but I assume I'm jumping the "data link connector?" I looked through my Haynes manual, and could not find where this is located... also looked underneath the dash on the driver's side. If someone could tell me where this is on my '92 Park Ave, it'd be great. Thanks in advance.

Yes, you will be jumpering the connector (ALDL) Assembly Line Diagnostic Link, known as a DLC on 96 and later. You will find this connector under the drivers side dash, but you will have to look through a square cut out in the panel to see the connector, as it is recessed behind that panel, almost directly under the steering column.

Mike