2 ohm wiring

the subs im getting are dvc 4ohm

and the amp im getting is 620x2 at 2 ohm

how do i wiring the subs to make them 2 ohm?

thx bret

can i bridge 2 dvc 4ohm subs?

the amp says 940x1 bridged at 4ohm

pictures get the point across much better than words can....
http://www.edesignaudio.com/ep2/wiring.htm

:D

thx alot
im trying to figure out this damn diagram

for your first post just look at the diagram for the single dvc sub wired in parallel

for the second post you want to look at the one down a bit, where it has 2 dvc subs and the ohm load goes from 4ohm -> 4ohm

i need the very last one, 2 dvc parrallel i think

i need the very last one, 2 dvc parrallel i think

yep, the very last one

The 2 voice coils for each sub are wired in series, then the 2 subs are wired in parallel.

I am guessing their is no way wo wire a DVC 2 ohm sub at 2 ohm?

I am guessing their is no way wo wire a DVC 2 ohm sub at 2 ohm?

a single dvc 2ohm sub to 2ohm?
no

So I know some of you guys have the ed15a.22 subs, I want to push 800 watts to them. They are dual 2 ohm, I have one. Anyone have any ideas on a good amp

avionixx 800.2
puts out 800x1 @ 4ohm

Elemental Designs also has a mono amp that puts out something like 1100 watts for a pretty good price. As with any amp though you wouldn't be able to crank the gain on it.

I think you're talking about the Tsunami db1100
It was a great amp for the price but a couple weeks ago they ran out of stock and they won't be produced anymore. The only way to get one now is to go used.