P11 Spoiler on a P10 install need help

Hey crew, I have a question regarding the installation of a P11 rear spoiler on a P10. The P11 spoiler only has 1 screw on each side to secure it. Is this enough to secure it to the P10? It's appear that it should have a second screw on each side but It was not supplied.

Can someone provide some insight to this problem.

Thanks

drill another hole? i think that would be an easy solution. :D it might be able to hold up but if your going around 100 or higher, it might start shaking or even fly off cause of all the pressure. :eek:

If you do drill another hole in your P10, make sure to go all the way through the support brace.

If you don't there is a chance the two will seperate and cause your wing to rattle.

Thanks.. I will most likely end up adding second screw. Plan to install it next sat....

Ive done it, its not hard, just follow the Nissan instruction guide included with your spoiler, and your set. View my site, I havent updated it in a while but its got a pic of my 96 P10 with a P11 G20 OEM Rear Spoiler on it. I now have my Silver 96 P10 G20 Completely converted over to a P11 Front end, It was a lot of work, but its now complete. As well as a DET with Pulsar LSD Tranny 5spd converted.

The installation of the P11 spoiler is done. it was a piece of cake... A total of 6 screws and 2 sided tape hold the spoiler together..

Thanks for all your help..

STR8MAXN