Last question I Promise

I found the half shafts for my car for a pretty good price now all I need is a "how to" in order to get them in. Are there any tricks to putting in my new axles without having to take apart the knuckle? Or a better question is How do I get my half shafts in and how to I get the old ones out?
Thanks
DJ

Go to the autozone and buy a haynes manual for your car. And yes you have to take the knuckle loose from the lower control arm to get the axles out. Be careful though b/c some ppl just pull on the axle to remove it from the tranny, but you can actually tear it into two pieces and then you will have a harder time getting it out. What you need to do is take the knuckle loose and then pry the axle loose with a screw driver or a flat pry bar.

OK I will get on this projec
thanks for the info