1994 GMC Jimmy Remote programing
rickrodt
08-19-2003, 12:11 AM
I was wondering if anyone had any luck in reprograming the transmitter on a 1994 GMC Jimmy? My daughter dropped the old remote and lost the little ground wire that grounded the batteries. Needless to say, after spending $70.00 at the local GM dealer, I do not want to waste any more buck there. The number on the new remote is ABO0104T.
Thanks,
Rick
Thanks,
Rick
Shortbus
08-19-2003, 07:09 PM
Ground pin G of the Data Link Connector (DLC)
Press any button of the first transmitter to be programmed.
The control module will respond by locking/unlocking doors and activating rear window release.
Press any button of the second transmitter to be programmed. (if used)
The control module will respond by locking/unlocking doors and activating the rear window release.
Remove the ground applied to pin G of the Data Link Connector.
Transmitter operation is verified by locking and unlocking the doors and activating the rear window release.
Press any button of the first transmitter to be programmed.
The control module will respond by locking/unlocking doors and activating rear window release.
Press any button of the second transmitter to be programmed. (if used)
The control module will respond by locking/unlocking doors and activating the rear window release.
Remove the ground applied to pin G of the Data Link Connector.
Transmitter operation is verified by locking and unlocking the doors and activating the rear window release.
Automotive Network, Inc., Copyright ©2026