motor swap

k, heres the prob, i have a 90 civic with a 1.5 with a 4 speed n i want to do a motor n transmission swap to a b16 with a 5 speed trans, n i was wonderin if the mounts would match up or do i need customizing, also the axles for the trans i assume i have to change the hubs too cause of the splines? with the harness is that hard to switch in a civic for when i do the swap?

You'll need to do some modding, including mounts, wiring, ECU, tranny, (engine of course), and axles. You should be able to keep your hubs. It's not too bad of a swap, but you'll want to do your homework first. Check out The Hybrid Pages (http://www.hybrid.honda-perf.org) they have some really good stuff, just look under the 4G tech section. The wiring isn't too easy, but they have diagrams for it there that will allow you to keep your original harness.

yah you need

mounts 200-500
b16 motor with cable trans. 800-1200
shift linkage - about 150
integra axels (2g) 50-300
some on to wire it -about 200-400

:grinyes: then you will run like a champ! :grinyes: