99 suburban keyless entry

i would like to know how to program my 1999 suburban's keyless entry remote that i jut purchased.


Thanks

When reprogramming the remote control door lock reciever, All transmitters must be programmed at this time in order for the transmitters to operate the vehicle. Transmitters not programed at this time will not work and the procedure will have to be redone with all the transmitters.

Ground pin 4 to pin 8 of the data link connector (DLC). The receiver will respond by locking and unlocking the doors, and activating the liftgate window release (if equipped) within 2 seconds.
Press and hold the LOCK and UNLOCK buttons simultaneously on the first transmitter to be programmed until the locks cycle (approximately 10 seconds).
Repeat step 2 for up to four total transmitters to be programmed (if available). The receiver will respond by locking and unlocking the doors and activating the liftgate window release (if equipped) within 2 seconds.
Remove the ground applied to the DLC.
Lock and unlock the doors in order to verify the transmitter operation.
Activate the rear window release in order to verify the transmitter operation.

Worked like a champ on my 99 Tahoe!!

Thanks

Check out the following link for pics of the data link connector, be sure to read the follow up posts for extra instructions on pin 4 and 8 grounding bc the picture has been rotated.

http://forums.vmag.com/suvsuburban-0902/messages/5095.html