Our Community is over 1 Million Strong. Join Us.

Stop Feeding Overpriced Junk to Your Dogs!

GET HEALTHY AFFORDABLE DOG FOOD
DEVELOPED BY THE AUTOMOTIVEFORUMS.COM FOUNDER & THE TOP AMERICAN BULLDOG BREEDER IN THE WORLD THROUGH DECADES OF EXPERIENCE. WE KNOW DOGS.
CONSUMED BY HUNDREDS OF GRAND FUTURE AMERICAN BULLDOGS FOR YEARS.
NOW AVAILABLE TO THE GENERAL PUBLIC FOR THE FIRST TIME
PROPER NUTRITION FOR ALL BREEDS & AGES
TRY GRAND FUTURE AIR DRIED BEEF DOG FOOD

ST-10 W.G. 4 speed manual linkage


Jester63
07-30-2003, 04:42 PM
I just purchased a 1971 Nova w/ 400 small block and ST-10 Borg Warner 4 speed manual transmission. It has a Hurst shifter, but the linkage is reversed - prev owner said there wasn't enough room in the tranny tunnel. Has any one had experience with this tranny setup? Should I get a new shifter and linkage? What are my options?

Thanks,
Jester63
a1supersport
12-05-2003, 07:29 AM
You could cut a section of the trans tunnel out, install the linkages correctly, and either modify the original piece you cut out, so it'll fit, or make another one from sheetmetal. I'm not sure if any of the Nova catalogs sell trans tunnel replacements, but I've seen a couple of them that sell a partial trans tunnel. Good Luck :)

Add your comment to this topic!