Combat II Rx-7

Yea last night i finally got back into modelling after a two month break and i bought the combat II veilside Rx-7 and i put all of the ground effects on and i am in the process of primer and i have a question i am doing one side at a time but there seems to be some sort of fuzz or something devolping on the hood from i suppose the after spray but i have no idea anyway what grit of sand paper should i use to take some of the little dirt pieces out and stuff?



I will post pics with the next hour or so

Didn't get any english lessons while you were away then?:iceslolan

Don't even start with that crap. ALright i was in a hurry shut just dont talk in this thread if you dont wanna see it

I guess you could use 2000 grit. :smile:

Maybe even a little higher.
I think a little higher would be good to because if it's not high enough when you re-prime there might be scratches.

:useless:

:iagree:

or a high abrasive scratch removal compound like GT27 or alike, may be and easier way to get an even removal or surface than 2000 grit