Did I fry my ECU !!?? Help please.

'01 3.0i auto;
This morning I was trying ton confioirm Peak code 7b (Thermostat map control) which as I understand, is related too the heating element of the main Thermostat (2 prong connector on top, just behind the top of the fan blade).

To check that I was getting power to the plug/heater element, I connected my volt meter to the 2 prongs in the plug/harness side and turned the key on while watching. The meter bleeped a bit but nothing, so I dicided to start the engine and see if that would bring the power up. No start.

It turns over but wouldn't start. Replugged the connetor - same. Checked all related fuses - OK. Disconnected the battery for an hour - same.

Any help on something like this??

THANKS IN ADVANCE!!
Worried
http://s1.bimmerfest.com/forums/images/misc/progress.gif

you need a ecu tools and you can find some good ones in xcardiag.com
i had buy some from it and they are cheap and good

I broke that sensor off in the housing and its been dangling in its clip for 7 years.
Check f or other plugs you 4got to plug in.