02 Accord Radius Arm help

I have a 02 Accord, 4 cyl, LX, auto trans, and I pulled the trans which had me pulling the sub-frame assembly. I had to remove the radius arms to pull the sub-frame. Unfortunately I didn't notice which way they were installed and trying to figure out which way they go? Is there a right or wrong way to install the arms? Is the natural bend going out or in on the drivers side? What about the passenger side?

http://www.hondaautomotiveparts.com/auto/jsp/mws/prddisplay.jsp?inputstate=5&catcgry1=ACCORD&catcgry2=2002&catcgry3=2DR+LX&catcgry4=KA4AT&catcgry5=FRONT+LOWER+ARM

http://www.hondaautomotiveparts.com/auto/jsp/mws/catimgs/13s8201_b2710.png

Thanks for the diagram...The way I had installed them were the passenger side the bend went upwards and then on the drivers side I had it with the bow to the outside. When I went to put the undershield on, it was hitting on the drivers side arm. So I changed it to where the bow was to the inside but left the passenger side with the bow upwards. I will have to go change that this evening.

If you ever need parts diagrams check www.hondaautomotiveparts.com