Our Community is over 1 Million Strong. Join Us.

Stop Feeding Overpriced Junk to Your Dogs!

GET HEALTHY AFFORDABLE DOG FOOD
DEVELOPED BY THE AUTOMOTIVEFORUMS.COM FOUNDER & THE TOP AMERICAN BULLDOG BREEDER IN THE WORLD THROUGH DECADES OF EXPERIENCE. WE KNOW DOGS.
CONSUMED BY HUNDREDS OF GRAND FUTURE AMERICAN BULLDOGS FOR YEARS.
NOW AVAILABLE TO THE GENERAL PUBLIC FOR THE FIRST TIME
PROPER NUTRITION FOR ALL BREEDS & AGES
TRY GRAND FUTURE AIR DRIED BEEF DOG FOOD

Transmission Guys Need your Help!


xclodbuster
06-24-2010, 02:58 PM
I'm replacing my transmission filter on my 2001 Yukon (4L60-E). While putting in the new filter seal I noticed a small strip of gasket material right in front of the seal that is torn, not sure if it was already torn or if I inadvertently did it. However, I need to know if this has some importance or is it just an overhanging gasket?

SEE PICTURE: The piece I’m referring to is at the end of the screw driver and the tear is just left of the screw driver.

Thanks for any info!

http://i111.photobucket.com/albums/n123/chromebullet/DSC03879.jpg
maxwedge
06-24-2010, 03:27 PM
Not an issue just the edge
xclodbuster
06-24-2010, 03:45 PM
Not an issue just the edge

Thank you for responding...... should I cut that piece off so it does'nt come off? Not that it feels like it would but just to stay on the safe side.
maxwedge
06-24-2010, 07:55 PM
If it is brittle, looks like it could crack, you could remove it, but this is not normally an issue.

Add your comment to this topic!