99 suburban power door locks working themselves

Recently installed new power door lock actuators. Have keyless entry. Arrived at destination and locked doors with remote and all door locks continue to operate as if the lock button is being pressed over and over again. Tried just locking doors with switch on drivers side and same problem still occurs. Checked switches and found no problems. When this problems occurs I am unable to use remote to unlock doors. Used key to unlock drivers door and pushed unlock button, door locks unlocked and then immediately locked by themselves again. Any Ideas would be greatly appreciated.

Best regards
Sevenfold70

Doubt my input has any bearing on your situation............but I left my windows down in a rain once and moisture got into the mechanism and caused the door locks to have a mind of their own until it dried out.

Found problem was from armor all. Got down in between button and side causing the button to stick just enough like if you were pushing and holding it in lock position. But to look at button it seemed to be in normal position when not being pushed.