tazim

Hi guys i am having transmission problems with my Acura el 2000 the CEL light came on i used an odb2 code reader to read the codes # PO700 Transmission shift solenoid & PO740 Torque convertor clutch solenoid i check the ohm reading on both solenoids the Hanes manual said it should be 12.0 to 25.0 ohms on the ones that was on the car & the used ones both reads 14.5 ohms which is good i replace both with the used ones replace trans fluid after a week the CEL light came on again some times from second to third it would slip a little not all the time need some help to solve this problem.

Thanks

TAZ

steviek

well this should be in the acura forums

__________________
FP 18g turbo e3 o2 & mani, 3" exhaust, , 7 bolt, wiseco/eagle, walbro 255hp re-wired, Aeromotive FPR, FIC 1150cc, injen intake, greddy RS, aem wideband, turbo xs mbc, act 2600 clutch sprung 6 puck, BC 272's, dsmlink v2.5, ETS FMIC, Devils Own, JMF SMIM.
18 Inch chrome rims
In closet AEM Fuel Rail, SS Lines,
1997 TSI AWD
Diamonds Are 4Ever
12.7 @ 107
http://i83.photobucket.com/albums/j2...y/DSC00461.jpg

david-b

Moving to the Acura forums.

__________________
95 Eagle Talon ESi-T 5spd
Eagle Rods. Weisco 8.8:1 pistons, Crower Stage 2 Cams, Crane Titanium Springs/Retainers, Ported Head/IM, 55mm TB, Fidanze 4.3 Clutch & 8lb Flywheel, Turbonetics 54trim, OBX Ramhorm Manifold, Tial WG, 1G BOV, FMIC, 750cc FI, Vortec SFMU, Walbro 255hp, MSnS, UDP, MSD coil/wires


01 Pontiac Grand Am SE

georgelopez415

Replace the transmission and torque converter. Replacing solenoids will not fix the problem. It's internal.